mesh belt dryer/ mesh belt chain dryer/ conveyor mesh belt dryer/ chemical drying
Product DescriptionIntroduction of Conveyor mesh belt hot air dryer
Materials are uniformly put on the mesh belt dryer machine by the feeder. The mesh-belt uses generally
12-60 mesh stainless steel wire net and it is drawn and moved inside the drier by a transmission device.
The mesh belt dryer machine is composed of several units. For each unit, the hot air is circulated separately.
Some exhausted gas is discharged with a special moisture elimination blower.The waste gas is controlled through an
adjustment valve. The hot air passes through the mesh belt covered with the material from the top to the bottom or from
the bottom to the top and this will complete the heat and mass transfer process.This process will bring material water
away. The meshbelt moves slowly, Running speed can be freely adjusted according to material temperature.
The final products after mesh belt dryer machine will fall into the material collector continuously.
Features of Conveyor mesh belt hot air dryer
(1)hot air from bottom-up and top down cross through material, increase contact area with the hot air of material,
(2)whole machine material is stainless steel.At the bottom of the inner cavity full welding, rounded corners, makes the
machine in working condition with the outside world without wind phenomenon, convenient cleaning discharged from
chamber to ensure product quality.
(4)fully enclosed structure, ensuring material is not contaminated, improve the thermal efficiency, improve working conditions.
(5)adopt unique internal air supply device, can not only improve material and improving drying speed
(6)hot air inlet is builtin in the center, and the heater in the air inlet for the specially crafted filter, filter the loop is the fine powder
and debris to ensure that the heater is internally clean; there is access door on one side , easy to access and clean.
(7)Dryer is designed for four layers, from the top layer to down layer, the material can be rolled over.
(8)Temperature can be controlled by steam regulating valve, digital display.
(9)Belt speed by frequency conversion, can effectively control material requirements.
(10)All air inlet is equipped with the filter to ensure clean air intake .
(11)centrifugal fan, high wind pressure , large air volume, low energy consumption, high air penetration rate.
Specification
Type |
YHBD0.8x8m-3 |
YHBD1x20m-3 |
YHBD1.5x20m-3 |
YHBD2x20m-3 |
YHBD1.5x30m-5 |
Length(m) |
8 |
20 |
20 |
20 |
30 |
Layer |
3 |
3 |
3 |
3 |
5 |
Mesh Belt Width(m) |
0.8 |
1 |
1.5 |
2 |
1.5 |
Moisture before drying (%) |
8%-12% |
8%-12% |
8%-12% |
8%-12% |
8%-12% |
Moisture after dried (%) |
1%-3% |
1%-3% |
1%-3% |
1%-3% |
1%-3% |
Power(kw) |
3 |
2.2x3 |
3x3 |
4x3 |
5.5x5 |
Drying Temperature(°C) |
70-300 |
70-300 |
70-300 |
70-300 |
70-300 |
Capacity(T/H) |
2 |
10-15 |
20-30 |
35-50 |
55-60 |
Packaging & Shipping 
Company Information 
FAQ
