Automatic continuously working;
Pot body made of 4mm 304 stainless steel
Pot body shell made of 1.5mm 304 stainless steel.
Water leakage test to make sure the leakproofness after welding.
Aluminum silicate insulation materials is filled between pot body and shell.
Drain valve is installed on the bottom of fryer
Oil vent installed on the in-feed of the fryer to prevent floating and remaining at the entry
oil temperature is tested by sensor and transfer to controller. It will stop heating after reaching the set temperature and alarm if beyond set temperature
Two temperature measurement point, control temperature of each parts of fryer respectively
Heating tubes made of stainless steel
Each group of heating tubes can power off separately to change the total power
Heating tubes installed in middle of conveyor belt, can save space and oil
Belt speed is frequency controlled
Type of belt: spiral mesh belt
The mesh belt holder made of 3mm stainless steel.
The exhaust cover and belt holder can be lifted individually, easy cleaning
The bearing and seat is made of stainless steel 304.
The gap of double belt is 30-60 mm(adjustable)
Transmission use gear reducer with low noise.
Scraping system: at the lower part of the mesh belt, there are boards whose distance is about 30cm. It can continuous scraping the potato starch to one side of the washing machine
Exhaust cover is made of 1.5mm stainless steel 304.
The cover and exhaust pipes have vapour extraction systemTwo fume Exhaust pipes ,each is 6m long,made of 304 stainless steel.
Axial flow fan installed on the end of each exhaust
Control valve installed on the bottom of exhaust seat
Use chains,screw and electric hoisting system.
Can hoist the fume exhaust cover individually
Can hoist the cover, belt holder and heating tubes together
Convenient to clean the mesh belt and fume exhaust cover
Use the safety bumper to make sure the belt holder can not fall down when it lifted
Automatically cut off heating tubes' power when hoisting the cover.